A pinhole leak dripping inside a wall, corroded galvanized pipe finally giving out, or a slab leak that's been driving up the water bill for weeks — pipe failures range from a slow drip to a real flood. Our Gateway technicians repair copper, PEX, and galvanized systems alike.
Copper, PEX, CPVC, and galvanized steel repair are all within our Gateway technicians' regular scope of work.
We locate the exact leak point with detection equipment before opening any wall or slab.
An actively leaking pipe gets priority routing across Gateway to limit water damage.
You'll get a written price once the leak is located and the repair scope is clear.
From a single pinhole leak to a full section of corroded galvanized pipe, our technicians match the repair to the actual damage.
We check nearby sections of pipe too, since one pinhole leak sometimes signals broader corrosion.
Soldered joint repairs and section replacements are handled to code, with proper flux and fitting technique.
PEX repiping is often faster and less invasive than replacing pipe in-kind.
We assess how much of the galvanized system is affected before recommending partial versus full replacement.
Electronic leak detection locates the exact point of a slab leak before any concrete is opened.
We repair the immediate break and can advise on insulation or heat tape for vulnerable lines.
Active visible leaks get priority dispatch across Gateway.
A technician arrives with detection and repair equipment matched to your pipe material.
You'll know exactly what's being repaired and what it costs before we start.
We test the repair under normal water pressure before calling the job done, then back it in writing.
"Pinhole leak behind the washer — found it and repaired it same day without opening the whole wall." — Homeowner, Gateway
"Frozen pipe burst over a cold weekend, they repaired it and suggested insulation to prevent a repeat." — Gateway resident
"Soldered joint repair was clean work, no leaks since, and reasonably priced." — Gateway customer
Our pipe repair technicians cover Gateway and the surrounding Gateway, AK area, with detection equipment on every truck.
We locate the leak first, which keeps the repair opening small and targeted.
It depends on how much corrosion is affecting water pressure and how much of the system is original.
Both are solid choices — we can walk through the tradeoffs for your specific situation.
Pricing is confirmed after the leak is found, before repair work starts.
Often yes — a single burst section can usually be spot-repaired rather than replacing the whole line.
We aim to minimize the opening required, though every slab leak is assessed individually.
Call +1-855-718-1500 for pipe repair in Gateway, AK.
Call +1-855-718-1500